Stay informed about the latest developments in cabinet manufacturing, IP rating standards, outdoor enclosure technology, and industrial cabinet solutions.
This paper reviews the high-frequency inverters for WPT systems, summarizes the derived topologies based on power amplifiers and H-bridge inverters, investigates the main factors restricting the development of high-frequency inverters, and analyzes the research directions for future development. 1. Introduction
A high-frequency inverter circuit is a combination of a low-frequency power inverter circuit and RF power amplifier circuit, so, drawing on various types of switching mode power amplifiers in RF circuits to be applied to the WPT system is a very sensible choice.
With the development of high frequency inverters, the volume and weight of inductors can be reduced, but the core loss and heat generation increase with the frequency, which will lead to the deterioration of inverter working conditions and lower efficiency.
This research was finally successfully applied to the CPT system . The University of Tennessee validated the performance enhancement of GaN for high-frequency inverters in WPT systems by accurately modeling high-frequency transients in the junction capacitance of GaN devices with good heat dissipation design.
If there are many such power generating sources to transmit electricity to the power grid, the power quality of the power grid will be seriously degraded. Therefore, this type of photovoltaic power generation system must be equipped with anti-reverse flow equipment to prevent the occurrence of reverse power.
The photovoltaic system with anti-backflow is that the electricity generated by the photovoltaic is only used by the local load and cannot be sent to the grid. When the PV inverter converts the DC point generated by the PV modules into AC power, there will be DC components and harmonics, three-phase current imbalance, and output power uncertainty.
If the solar power input is reversed, the power will form a short circuit through the anti-parallel diode. According to the characteristics of the solar module, the voltage of the solar power supply When pulled down, the voltage value is only the sum of the forward voltage drop of the two diodes, which will not damage the electrolytic capacitor.
When reverse current is detected, the meter communicates the backflow data to the inverter via RS485 communication. The inverter responds within seconds, reducing its output power to ensure the current flow into the grid is nearly zero. Anti-Backflow Solutions Different configurations are available to meet various scenarios:
